LED Canopy Light - CPA
- 30W, 45W, 63W, 30W/45W/63W Wattage Selectable
- 4000K. 5000K, 4000K/5000K CCT Selectable
- AC120-277V/120-347V
- Quick mount plate for surface or junction box mounting.
- With Microwave sensor and Photocell option
- DLC, cUL, RoHS certificate
Parameter

Model | Wattage | Lumens @50K | Input Voltage | CRI | CCT |
XSY-CPA30W-XXKUV-XYZ | 30W | 4050lm |
AC120-277V |
>70 |
40K |
XSY-CPA45W-XXKUV-XYZ | 45W | 6075lm | |||
XSY-CPA63W-XXKUV-XYZ | 63W | 8505lm | |||
XSY-CPA(30/45/63)W-XXKUV-XYZ | (30/45/63)W | 4050lm/6075lm/8505lm | 40/50K selectable |
||
XSY-CPA(30/45/63)W-(40/50)KUV-XYZ | (30/45/63)W | 4050lm/6075lm/8505lm |
LED Canopy Light Fixture - CPA
The CPA Series is the latest generation Canopy Light of XSY Lighting, it is highly cost-effective, and offers complete configurations. The CPA Series delivers 4,050lm to 8,505lm lumens, which can replace 100W-250W HID luminaires. The additional function of Color Temperature and Wattage selectable.
Installation methods
Surface Installation

- Remove the junction box mounting plate from the top of the fixture by loosening one side screw and sliding the fixture plate out from the holding brackets on the top of the casting.
- Install the mounting plate to the junction box with two or four screws (not provided). The bracket should be positioned to allow the fixture to be “square” with the sides of the canopy the fixture is mounted to.
- Hang the fixture from the support spring while wiring the unit. Bring the fixture input wires from the top of the fixture and connect them to the power leads in the junction box – black to black (hot), white to white (neutral), and green to green (ground).
- Connect the main housing to the junction box bracket. Hold in place while reinstalling one side locking screw.
- Turn on the power. The fixture will come to full output in several seconds.
Note: Do not remove the bottom lens or touch the LED optics. All LEDs are preinstalled and ready to operate.
Note: To weatherproof your outdoor installation, all gaskets must be seated properly and all screws inserted and tightened firmly. Apply weatherproof silicone sealant around all edges between the fixture housing and mounting surface.
Junction Box Installation

- Feed input leads through a 6" x 3/4" threaded conduit pipe (not supplied), apply RTV silicone between threads, and screw conduit pipe into fixture threading.
- Apply RTV silicone at the joint between the fixture and the pipe.
- Attach the fixture with conduit pipe to the junction box.
- Bring the fixture input wires from the conduit pipe and connect them to the power leads in the junction box black to black (hot), white to white (neutral), and green to green (ground).
- Reconnect power at the circuit breaker and test the fixture. The full output should occur within seconds.
Note: Do not remove the bottom lens or touch the LED optics. All LEDs are preinstalled and ready to operate.
CPA LED Canopy Light Applications

Gas stations

Parking garages

Corridor

Underpasses